Chainsaw Pole Pruner Telescopic
Two Stroke Petrol * Critical Information for our 2 Stroke Machines
<aside> đź’ˇ Read all Caution notes. Always return tools in a clean condition please.
</aside>
Don’t cut palm trees see video
Chainsaws always become blunt during use. The time in which it takes to becomes blunt depends on the type of wood being cut and how dry the wood is. The drier the wood the faster the chain becomes blunt. The chainsaw will be sharpened at no extra charge when the chain becomes blunt. This can only be done at one of our branches so the machine must be returned to us for sharpening. Sharpening takes approximately 15 minutes. Please don’t rant and rave about a chainsaw that does not want to cut because it is blunt. All our saws are sharp when they leave our shop, we have explained how and why this happens and what the solution is. Chainsaws always become blunt after use. The time in which it takes to becomes blunt depends on the type of wood being cut and how dry the wood is. The drier the wood the faster the chain becomes blunt .
Make sure the Brake is not engaged, pull it back towards the rear of the machine to disengage is completely Switch the stop button “on” and pull the choke all the way out. Place the saw on the ground.
Hold the saw firmly on the ground while you start it. Put your right foot through the rear handle and grip the front handle firmly with your left hand. Pull the starter cord with your right hand until the engine fires. Now push in the choke without moving the throttle control. The saw has an automatic start throttle setting.
Note! It is very important that you push in the choke after the engine fires the first time, otherwise the engine WILL “flood”.
Pull the starter cord until the engine starts.
Lift up the saw and press the throttle a few times to get a feel for the way the saw reacts to the throttle.
If you suspect you have flooded the machine, then make sure the choke lever is pressed in and continue to pull until it starts. If is does not start after 10-15 pulls you will need to return the machine for us to clean out the flooded chamber